Micronics PCI/ISA System Board D6-IN User Manual download pdf (Page 20)

M6DPi System Board Manual

Chapter 3: Installing the M6DPi

Installing the M6DPi

Installation of the M6DPi system board depends on the

type of case you use. The M6DPi is designed for the full-

size AT form factor and is likely to be limited to tower

cases. NOTE: If you are unfamiliar with installing a

system board, Micronics highly recommends that you

read the computer user’s manual or contact your dealer’s

technical support department.

Tools Required

Micronics recommends using the following tools to in-

stall the M6DPi:

❏ Small Phillips screwdriver

❏ Tweezers or a pair of needle-nose pliers

❏ Tray (to hold loose screws)

Equipment Required

Micronics recommends using the following equipment

with the M6DPi for a typical configuration:

❏ Chassis with standard hardware (tower case prefer-

able).

❏ A high-quality power supply capable of providing

continuous power within a 5 volt range. A power

filter may be used with a noisy AC power source.

❏ PS/2 mouse and compatible keyboard.

❏ Eight ohm speaker.

❏ Standard ribbon cables for internal connections.

❏ Standard power cord (grounded).

❏ Heat sink with cooling fan for each CPU (required).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 80 81

No comments

Micronics PCI/ISA System Board D6-IN User Manual Page 20